help!!~~~~~ my phone dead 3 years still not recover. T.T

[mihow]

my e398 dead after flash. i cnt start the phone and my battery has no current n i cnt charge it with usb.... help!!!!!!!! wat can i do?? can anyone teach me step by step. plz help me... (post the software's link if possible)- send it to my mail box (weehua@hotmail.com) . thxss so much

[jzzz]

Firstly you must buy a desktop or travel charger.
make sure the battery is fully charge.
Second you need to download my reviving tool.
and follow the step carefully.
you can ask me more for your problem.

[mihow]

thxsss for the reply... but do u hav any other way to charge the battery? cos i donno where can buy the charger n i cnt use the original charger to charge the phone.

[MarkoP]

You can also charge your battery directly on wires,you have to cut the orig charger   try to find another moto charger and cut it
CMIIW

[mihow]

  charge direct on the wire... how to do it? n wat is CMIIW? ^.^

[jzzz]

What is your country?
in my country (indonesia) there are many shop sell desktop charger about $ 20.
markop mean that you should cut your connector charger and connect the cable to +- of the battery.

[MarkoP]

Yup... CMIIW means correct me if I'm wrong... desktop charger in my country is about 8 euros... it's a good price for alive phone

[PaulyQ]

Check the link below

https://motohell.com/index.php?topic=5445.0

worked for me.

The Direct Wire method will charge your battery... how 2:

1) Mark ONE of the wires with correction fluid/tippex around 6-8 inches from the part that plugs into the phone.
2) cut the wire at the point were there was correction fluid
3) strip around 1cm of wire making sure you know which one is marked - this is important as you need to re-join the wires later in the correct way.

4) Sticky tape one wire to positive on battery, the other to negative.

LEAVE TO CHARGE OVERNIGHT!! If it's original OEM battery then it will auto switch off.

Put battery in phone whilst holding * and # and you should get to the bootloader.

Try flashing your phone, follow the directions in the link above. Worked for me perfectly.

As for software, check the main page HERE and do a bit of reading.

[jzzz]

Wow, too expensive mark.
in my country with the same price,i can get a new original charger.
but if you recommand to cut a charger,so he should make his charger to be a sacrifice.
and he need buy a new one for charge his phone next.

[MarkoP]

Well,buying a desktop charger is always better solution...

[PaulyQ]

seriously.. try my method.. works 100%

Forget the desktop charger!!

[jzzz]

Yeah i see what you mean.
But everyone doesn't always understand how to do soldering well.
So it's gonna be complicated for them.

[mihow]

yo huu~~~~~ my phone has fully charge... but i cnt open boot mode.?! so wat to do next?

[jzzz]

download my reviving tool.
n look the readme file about how to revive a dead e398.

[PaulyQ]

to open bootloader...

hold down * and # as you turn the phone on.