Quick Guide How To Apply Patch On V3xRequired
- P2KTools VS 3.0.9
- Flash & Backup 3.7 Recommended
- .fpa patches Multifont Patches & Rainbow Elf Loader / Patches Pack 85.9B.E6P
STEP ONEE6P RSA Locked CG1 must be flashed and then rsa should be removed at first.
- At first, we have to bypass the RSA.
1). Open P2kToolsVS and select 2). "FLASH Mode"
-Then put the phone in bootloader-mode
3). Go in "Repair Rainbow POG" menu 4).and make sure you are in right bootloader 5). then check "Automatic (Direct on phone)"
6). Then click on Remove RSA (V3x, E770)
After the click, there will appear a warning message, click on "Yes". After a while, there will appear another warning, DON'T click on "Yes", first exit from the boot-mode (pushing the red button) and enter again (with the usal * # and red button). Then click on "Yes" and on the phone will appear "Sw upgrade in progress..." Wait that the process finish and then, if the phone doesn't restart automatically, switch on it and look if everything ok.
Credits to fabo.92 for the guide & sir Semseddin for corrections
STEP TWO
1) Make sure your phone connected to pc.
2) Change Active Phone Profile to MOTOROLA V3X.
3) Select and tick CG1 for backup.
4) Select Read Data for begin backup.
5) Backup in progress,the phone automaticlly turn to Flash-Mode
and wait until backup is finished.It will take a while for backup.
6) when backup already done, click on Frimwares tab.
7) Select files that have been backup.
8.) Tick on Apply Patches and 9) Select Patches
10) Add patches that you want to 11) from your patch FOLDER.
12) When you done with selecting patches, press OK button.
13) Press QUICK FLASH if you are ready to flash CG1 patches to your phone or
14) You can save it as *sbf or *shx and flash with Motokup
later.
thanks to all..
here the pdf file..
http://www.4shared.com/file/82883028/e7fb041b/Quick_Guide_How_To_Apply_Patch_On_V3x_4_Motohell_.html
